XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

Yes, we can transfer the data like indicated but not sure this is the most optimal option. Can you please explain what you are trying to do? On the camera side what serializer are you going to use?

Hi，I am using the bq40z50-r2 chip for 2S1P battery packs. I now want the battery pack to be able to actively turn on the discharge MOS when plugged into the power supply device, and then automatically ...

I am using CLA in my program. I have a function defined on a separate .c file, which I need to call inside Cla1Task1 in CLA file. The "--cla_default" option has choosen under "C2000 Compiler -> ...

I am using the EMIF interface to access both an external SRAM and an FPGA. Do you recommend adding series resistors (10-22 ohms each) to the EMIF signal lines, since the interface will be running at ...

The value of Rfilter is 100 ohms, 0.1% tolerance, for each resistor <- while this value is 10x the recommended value, I suspect it does not have a great impact on our operation, your feedback would be ...